NEW! Faster Search Option

Loading
Home › Forums › Fine Woodworking Knots › Jigs, Fixtures, Tips & Tricks

Routing concave curbe

bob71701's picture

Routing concave curbe (post #166586)

bob71701 on Wed, 04/20/2011 - 05:47 (updated 04/20/11 - 04:52) 
in

I am new to routing and am trying to build shutters  for stained glass with a curve at the top.  I ma making them with rail and stile router bits on a router table but can;t figure out how to route the curve with a bull nose bit , inside curve.  Any help and advise would be greatly appreciated.

-A +A
RalphBarker's picture

routing coives (post #166586, reply #1 of 1)

by RalphBarker in reply to bob71701 [original] on Thu, 04/21/2011 - 13:50

(My fingers don't always spell the way I tell them to, either. ;-)  )

Sounds like a job for a tempalte against which a guide bushing can ride.