Pinfeather Board

Developed a feather board with a pin pivot to get a tighter fit and add leverage to the fastening process.   

Basically the slide that goes into the table saw or shaper slot has a 3/8" threaded hole for the knob with screw down... plus

a 1/4" pin.    The feather board has a 1/2" wide slot where the 3/8" screw is fasteneed through which gives it some movement.

The pin goes into 1/4" holes slightly oversized.   The feather board is rounded on the end.   The pin limits the movement of the

jig which is especially helpful on the large shaper that I run.    I plan to develop this idea further.