NEW! Faster Search Option
Loading
Hold down clamps
In a previous FWW article by Michael C. Fortune he had made a Mortise Jig that featured hold down clamps. Does anyone out there know a source for these clamps?
Print this page
Email this MessageNavigation
Recent Discussions
Lift mechanism needed 6 replies
Old plane vs new 7 replies
That "special" tool 6 replies
Buy American made 1 reply
Re: Holzman and Vega lathes 3 replies
Inca/Delta 20" Bandsaws 4 replies
Cast Iron Clamp 4 replies
Building a Floor Clook 1 reply
Music Boxes 1 reply
Star of David 3 replies
Hand Tool Grinding Angle Setups 11 replies
More Rust Hunter 1 reply
Lie-Nielsen Router Plane 3 replies
Regarding sharpening 2 replies
looking for lignum vitae mallet 28 replies
Best saw for dovetails 3 replies
Half lap joints 2 replies
Rolltop desk top 3 replies
Large Pins, small tails 4 replies
Adhesive to use for laminating MDF? 6 replies
Seasonal movement of Cherry 3 replies
Boxwood 5 replies
More on cutting thin cuts 4 replies
Can't see any videos 2 replies
Forced log-offs . . . again? 4 replies
Fix: Private Messaging Spam 13 replies
Get in touch with author 1 reply
hold-downs (post #162146, reply #1 of 2)
If you are referring to the article below, the hold-downs are toggle clamps, available through Rockler, Woodcraft, and various other suppliers.
http://www.finewoodworking.com/subscript...
At Rockler:
http://www.rockler.com/search_results.cf...
Mortise Jig (post #162146, reply #2 of 2)
Ralph, thanks for responding so quickly to my question. Unfortunately that wasn't the article. I've attached the PDF file that shows the hold down clamps in question. I also realized that I could email Mr Fortune, found his email and shot a note off asking for the same info. Again, thanks for your help.
David Adkins