Stone Mountain Router Bits?

I've been there and done that. Anyone that values their money will stay far and clear of any of these "value priced" router bits. They are NOT worth it. Look at the router bit review on FWW and see the comparison of bits. Also, look at the prices - most are not that much less than the "good ones". On occasion I have faltered, thinking I'd save a few bucks on a bit I didn't think I'd use much, only to regret it due to the much inferior job it did, not to mention the bit was good for only a couple of times. And then it got even worse. This is true of just about any of them from any but the few top bits. Personally, I use Whiteside and never have to think twice about it's quality. Generally, the cheaper bits are going to have a lot more "patterns" avaialble, somewhat a sign of quantity over quality. You can make just about any pattern of several basic GOOD bits, and that is definitely the way to go versus sacrificing quality. The best in my experienced opinion are Whiteside, Lee Valley, Infinity, Eagle ... in that order; and, I dare you to find that much difference in cost. And I'm sorry, though Peachtree has some fairly good stuff, they are not very high quality in their proprietary stuff. They are always the vendor with the biggest both at the shows, essentially selling the cheap stuff from China and knock-offs of the quality stuff. The old adage of you pay for what you get most assuredly applies here.